How To Use PROShaker 

Shaker Step 1

Shaker Step 1

STEP 1 - Power Up ProShaker After unpacking the ProShaker and finding an ideal location, plug the power supply into a 110 volt outlet. Then, plug the other end into the ProShaker.

Shaker Step 2

Shaker Step 2

STEP 2 - Load the bottle holder Place bottle of choice (inverted) into the bottle holder, as shown.

Shaker Step 3

Shaker Step 3

STEP 3 - Secure the bottle Secure bottle holder over the top of the bottle as shown. We do not recommend stretching the springs over their normal, active length of 3 inches as this can cause them to break. Broken springs are not covered by the manufacturer's warranty

Shaker Step 7

Shaker Step 7

STEP 7 - Rest Time Allow bottle to rest at least one minute after shaking to allow gel-polish to settle.

Shaker Steps 5 & 6

Shaker Steps 5 & 6

STEP 5 - Begin Shaking Press red button to begin 60 second cycle time. STEP 6 - Cycle Bottle will automatically stop mixing after 60 seconds. To interrupt 60 second cycle, press power button.

Shaker Step 4

Shaker Step 4

STEP 4 - Check the bottle Verify that the bottle is secure and in place.